GIDC Makarpura, Vadodara Engineering utilities since 1999 info@indoanushka.co.in +91 84017 28133
Indo Anushka Steam Technologies Enquire→

Steam · Air · Water networks · Energy conservation

Every kilogram of steam
you make should reach
the process.

Indo Anushka builds the strainers, separators, traps, silencers and condensate return systems that stop steam, heat and water leaving your plant unused — designed so they can be cleaned, watched and maintained without a shutdown.

S-CUBE ball float steam trap with inbuilt online cleanable strainer

S-CUBE continuous discharge float trap · inbuilt cleanable strainer · flow monitoring

1999Established in Vadodara
25+Years of manufacturing
17Engineered products
06Industries served
0Shutdowns to clean a strainer

01The problem

A steam system loses money quietly.

Steam and condensate loop with four loss points Steam leaves the boiler to a heating tank and a heat exchanger, and condensate returns through a strainer, trap and receiver. Four numbered points mark where steam, heat and water are commonly lost: direct injection at the tank, a choked strainer, a stalling exchanger, and flash steam vented from the receiver. STEAM CONDENSATE FLASH BOILER TANK HEAT EXCHANGER RECEIVER 01 02 03 04
  1. 01Steam blown straight into the tank leaves again uncondensed.
  2. 02A choked strainer needs the line isolated and opened up.
  3. 03The exchanger stalls, floods with condensate and hammers.
  4. 04Flash steam vents off the receiver and is never recovered.

Steam escapes uncondensed from a sparge pipe. A choked strainer forces a shutdown to clean. A stalled exchanger fills with condensate and hammers. Flash steam vents to the sky. Hot condensate is cooled so a centrifugal pump can handle it — and the heat you paid for goes with it.

None of these show up as a fault. They show up on the fuel bill. Our products are built around a single idea: put the losses where an operator can see them, reach them and clear them — online, with a valve, without a shutdown.

  • 01
    Clean online.MAINTENO strainers back-flush from a blow down valve. No opening up. No instrumentation.
  • 02
    See it working.MULTIVIEW cap-nut sight glasses sit after the trap so discharge is visible, and the glass is never pre-stressed.
  • 03
    Return the heat.MUTINY pumps move condensate at practically 100 °C on motive steam — no electricity, no instrumentation.

02Product index

Seventeen products, three families.

Hover a row to preview. Click for the application detail.

01Steam & Pipeline Equipment

Strainers, separators, sight glasses, traps and silencers for the steam and compressed-air network.

Modular Water Heating SystemMWHSPackaged direct and indirect water heating, without the losses of a sparge pipe. MAINTENO TigonY / T-TYPE STRAINERA Y/T-type strainer that is cleaned online — no opening up, no shutdown. Basket StrainerBSOutside-to-inside flow design so collected solids drain out without pulling the basket. MULTIVIEWDOUBLE WINDOW SIGHT GLASSA cap-nut sight glass that keeps the glass pre-stress free, so it lasts. S-CUBEBALL FLOAT STEAM TRAPContinuous discharge float trap with an online cleanable strainer and flow monitoring built in. Steam Trap ModuleSTMTrap, MAINTENO strainer and MULTIVIEW sight glass, factory assembled on flanged ends. THERMOJECTSTEAM INJECTOR100% steam utilisation, near-silent — the sparge pipe replacement. Vent SilencerVSExpansion-chamber silencer for vents, relief valves and blow-downs. FCATFLOAT TYPE COMPRESSED AIR DRAIN TRAPDrains moisture from an air receiver while keeping the compressed air in the system. MAINTENO MSEPMOISTURE SEPARATOR CUM STRAINERRaises dryness fraction and strains carry-over solids in one body. Moisture SeparatorWITH DRAIN MODULEHeader moisture removal, delivered piped-up and ready to bolt in.

02Condensate Recovery

Steam-operated pumps, flash vessels and combination systems that return hot condensate without electricity.

MTRPSFLASH + CONDENSATE RECOVERYFlashing and pumping in one compact skid that fits next to the equipment. MUTINYSTEAM OPERATED CONDENSATE RETURN PUMPReturns condensate at practically 100°C using steam — no electricity, no instrumentation. MUTINY MINICOMPACT CONDENSATE RETURN PUMPA low capacity pump for small quantities from remote locations, at minimum capital cost. MUTINY PTCPUMPING TRAP COMBINATIONTraps under normal pressure, pumps when the exchanger stalls — it senses and switches itself. MAX-FLASHFLASH VESSELSTurns high pressure condensate into usable low pressure steam, free of cost.

03Innovative Products

Purpose-built answers to problems the standard catalogue does not solve.

AIRVENTAVDT — AIR VENT WITH DIAL THERMOMETERRemoves air and non-condensable gases that quietly destroy heat transfer.

04Industries served

From Ankleshwar and Dahej to plants worldwide.

01 Food & Beverages
02 Chemicals, Colours & Dyes
03 Pharmaceuticals
04 Petroleum
05 Ceramics & Rubber
06 Paper & Textiles

05How we work

“To work with our customers and not for them.”

Under one roof: application study, design, fabrication and after-sales service. An enquiry that arrives as a line sketch and two pressures leaves as an application — the right product, sized, with the accessories it needs to keep working.

More about the firm→
  1. 01

    Study the utility

    Pressures, sizes, layout, what the equipment is actually doing and where the loss is sitting.

  2. 02

    Engineer the answer

    Select or design the module — trap, strainer, separator, pump — with the monitoring built in.

  3. 03

    Fabricate and skid

    Assembled, piped up and flanged in our Makarpura works so installation is a bolt-up, not a project.

  4. 04

    Stay on the line

    After-sales service on the principle the firm was built on — we work with the plant, not merely for it.

Next step

Tell us what your steam line is doing.
We will tell you what it is costing.

Send a line drawing, a photograph or just the pressures and sizes. We answer with an application, not a price list.